Updated part numbers for newer fan circuit.
Added pull up to SD_MODE on TMC5160.
Changed LED resistor to 10K on fans.
Assigned designators for Fans.
Updated TACH namess.
Renamed THERM_AN4 netname to TC_AN4
Deleted R96 between X-REF and PA6
Renamed X-REF netname to TC_AN5
Created TC_AN6 connected to PA2
Created TC_AN7 connected to PA3
Delete PA3_TIOB1 from PA3
Created TC_AN8 connected to PA16
Created netname PC8_PWML3 connected to PC8
Changed SC2-6 from PA3 to PC8
Created netname PC27 connected to PC27
Changed SC1-5 from PA16_SCK1 to PC27
Created port Fan4 on PB16
Created port Fan3 on PB15
Created port MIN_ES4 on PB15
Created port MAX_ES4 on PB7
Renamed REF-E1 to Tach0
Deleted R99 on E1-REF
Deleted R101 on Z-REF
Deleted R97 on REF-E2
Deleted R98 on Y-REF
Changed motor SCK to E3_STEP
Changed motor MISO to E3_DIAG
Created port E3_nCS on PB6
Changed motor MOSI to E4_STEP
Changed Y-EN to E4_DIR
E4_DIAG on PB5
E4_nCS on PB8
E5_STEP on PC19 (Z-EN)
E5_DIR on PA11 (E2-EN)
E5_DIAG on PB4
E5_nCS on PB22 (E1-EN)
E3_DIR on PB3
DRV_EN on PC9 (X-EN). This should be global enable for all drivers.
Added 2 endstops for 8 total.
Swapped pins on SC1 and SC2 with other ones to get extra ADC pins for more temp sensors.
Added 4 Fans schematic with dual low side driver copied from Einsy.
Still needs updated and consistent port names for TACH pins.
Still needs Designator numbers to be assigned.
Still needs old fan1 fan2 low power mosfet circuits to be deleted from Mosfets schematic page.
Still needs 10k resistor on red LEDs.
Summary: Port names for all the new Fans, Tachs, Temp Sensors, Stepper Drivers (E2 E3 E4_*STEP,DIR,nCS) pins added to Microcontroller schematic.