Input Voltage: 5V-15V(External Source 5V Pin) 5V (USB) or 3.3V (3.3V Pin). ONLY USE ONE VOLTAGE INPUT AT A TIME
Output Current at 3.3V : 1 A (External Source) 500mA (USB)
No Polarity Protection (External Source)
Overcurrent Protection: None

References

ESP32 Wroom 32 E datasheet p24 -> 3.3V pin needs one 22uF and one 100nF capacitors

ESP32 Wroom 32 E datasheet p26 -> GND Thermal needs vias between pads. Needed vias are too small for my manufacturer. I will use bigger vias

USB Hardware Design Guidelines for FTDI ICs p8 -> 10nF Cap + Ferrite Bead + 100nF Cap + 4.7uF Cap
I disregarded such heavy filtering for the easier to implement 1uF and 100nF cap given in the CP2102 datasheet
I added a polyfuse with Ihold=500mA and Itrip=1A.

USB needs 90 Ohm differential traces.
According to JLCPCB impedance calculator, with a JLC7628 prepreg and 6mil (0.15mm) space between lines
I have to use 9 mil tracks -> 0.2 mm
I will use a very short trace for D+ D- (around 2mm)
I have to place vias because of the pinout of USB C and CP2102. Some other people have done it with no problems

CP2102 datasheet p15 -> VBUS will be tied to REGIN. 1uF and 100 nF will be added.
CP2102 datasheet p15 -> ESD Supression Diode for all three inputs of USB
CP2102 datasheet p15 and p19 -> 100nF for VDD output, 4.7 uF is optional for higher current circuits.
CP2102 datasheet p23 -> The VDD or 3.3 output can only provide 100mA. I will not use this as a voltage provider for the ciruit. I will use the AMS1117-3.3
CP2102 datasheet p15 -> RST pulled up via 4.7k and SUSPEND~ pulled down via 10k.

ESP32