mirror of
https://github.com/oresat/oresat-star-tracker-hardware.git
synced 2024-12-12 09:05:38 +00:00
31 lines
1.5 KiB
Plaintext
31 lines
1.5 KiB
Plaintext
SCN == STENCIL CHANGE NEEDED
|
|
|
|
DONE - C8 0805 22uF should be 1210
|
|
DONE - see power plane on balls H10 and H11
|
|
DONE - C4 0805 10uF should be 0603 like all others on board, unless there is a compelling reason why not
|
|
DONE - re-number refers, though this might make the second rev confusing
|
|
DONE - it'd be nice if C18, instead of 2.2uF, could be 1uF, or use 2 1uF,
|
|
DONE - rename JTAG header CM1 to Jx
|
|
BOM - all parts should have correct MPN as attribute
|
|
BOM - D1 should user amber LED part, not green
|
|
DONE - 10uF 0603 should be 0805
|
|
- in attributes, note part numbers for different temperature grades for ICs, like CLVCH16T245MDGGREP vs 74LVCH16T245DGGRE4
|
|
IRRELEVANT - swap tx and rx on UART header
|
|
WHAT? - fix resistor on MIC842
|
|
DONE - separate C38 and C37
|
|
SKIP - RC circuit on camera reset, see AR0130 datasheet, pg. 14
|
|
DONE ON CAMERA - perhaps optional pullups on camera control lines
|
|
DONE - usb lines too close to C37
|
|
DONE- this USB ribbon cable is giving me issues, maybe use other type of connector
|
|
DONE - R12 was accidentally deleted(no cream)
|
|
DONE - R39 label on silk
|
|
DONE - c17 label on silk
|
|
DONE - breakout I2C0 !!
|
|
DONE - TPs on reset circuit
|
|
DONE - make font bigger(use minimum oshpark size)
|
|
UGH - labeled TPs would be nice
|
|
CANT? - would be nice if SD was closer to edge
|
|
DONE(TPS) - breakout I2C2 (maybe I2C1 as well)
|
|
DONE ON CAMERA- pullups/downs on all camera lines, with control buffer disabled, so that comes up and stays in good state until initialized
|
|
DONE - fix MIC842 footprint
|
|
DONE add debug board |