mirror of
https://github.com/uw-midsun/hardware.git
synced 2024-11-23 07:05:05 +00:00
b66164a648
* ELEC-269 Controller Board Rev 6.0 - Switched from OSC32_IN/OUT to OSC_IN/OUT to utilize HSE - Aligned silkscreen on PCB Note: No changes to pads, stencil will remain the same. * ELEC_269 Controller Board Rev 6.1 - Moved power supply components to the first sheet, deleted the second sheet - No changes to PCB or designators * ELEC-269 Controller Board Rev 6.2 PcbLib Changes: - Changed blue LED footprint to LED, 0603 - Changed 3D model of LEDs from a resistor to a diode PCB Changes: - Modified layout to have the two duracliks beside each other, also swapped 3v3/GND planes for more complete planes. TODO: Layout can be optimized more if needed * Deleted DIOC1805... footprint that was used for LEDs before * ELEC-269 Controller Board Rev 6.3 Moved a few components and traces around in order to preserve a better ground plane and power plane. Changed +12V to a 15mil trace. * ELEC-269 Controller Board Rev 6.4 - Flipped C1 and C2 for better routing - Aligned silkscreen - Added silkscreen and dot to indicate direction of 12V-3V DCDC module * ELEC-269 Controller Board Rev 6.5 Changed the following net names: - Added PWM_TIM1 to PA8 - Added PWM_TIM13 to PB0 - Added PWM_TIM14 to PA4 No changes made to schematic or PCB. * ELEC-292 BMS Carrier Board Rev 2.0 - Added 2k pull-up on MISO - Swapped pins on 2 pin duraclik for ISOSPI to match AFE board Also updated PCB layout. * ELEC-293 BMS Carrier Rev 2.1 - Deleted old current sense amplifiers and 5V LDO - Added another LTC6820 ISOSPI Interface - Started routing, to be continued. * ELEC-292 BMS Carrier Rev 2.1 - Finished PCB routing - Added test points for both SPI and ISOSPI nets TO DO: Complete silkscreen for all test pads and connectors * ELEC-292 BMS Carrier - Added 0 Ohms to the PHA/POL pins for flexibility - Added silkscreen for current sense connector * Saved project file * ELEC-292 BMS Carrier Board Rev 2.2 - Fixed silkcreen on the bottom layer - Generated gerber, NC drill, pdf, and 3D model in project output file * ELEC_292 BMS Carrier Rev 2.3 - Added a 0805 capacitor on the relay input - Improved silkscreen - Rerouted the fan and bat relay connections, fan is now further away from other components for PWM - Generated NC drill, gerber, and 3d model
3 lines
163 B
Plaintext
3 lines
163 B
Plaintext
AFE_isoSPI_Interface=PA4/SPI1_NSS,PA5/SPI1_SCK,PA6/SPI1_MISO,PA7/SPI1_MOSI
|
|
CurrentSense_isoSPI_Interface=PB12/SPI2_NSS,PB13/SPI2_SCK,PB14/SPI2_MISO,PB15/SPI2_MOSI
|